I took out the PCB of ane of my hard drive which is non getting detected only to bank check whether there's any burned caps or chip and I institute some corrosion/rust on the contact pads which makes the contacts with hard drive. I have uploaded the picture for the reference. How can I clean the corrosion/rust from the pads shown in red marked surface area? A little help would be great. Thanks.
Sep 22, 2022
7,678
382
35,890
906
Sep 22, 2022
7,678
382
35,890
906
#2
Employ a soft pencil eraser or a cotton bud dipped in isopropyl booze. Don't scrub too hard -- it is possible to overdo it and remove the gilded plating.
Aug ii, 2022
36
1
18,535
0
#three
Utilize a soft pencil eraser or a cotton bud dipped in isopropyl alcohol. Don't scrub too hard -- it is possible to overdo it and remove the gold plating.
Thanks for replying. I cleaned with eraser every bit well every bit with a isopropyl alcohol but the contact points are nevertheless dark in colour like they are permanently corroded/rusted. Should I add soldering on them? Volition information technology improve the contacts?
Sep 22, 2022
7,678
382
35,890
906
Thread starter
Similar threads
Forum
Replies
Date
X
Question Secure cleaning of laptops
Storage
four
A
Question Wiping/Cleaning my HDD after cloning to SSD.
Storage
2
Question Factory Reset to Clean Up Gaming Calculator
Storage
2
C
Question SSD not detected while clean installing Windows 10 (Old laptop)
Storage
0
5
[SOLVED] How to clean Windows 10 OEM USB flash drive and then I tin can utilize it for storage ?
Storage
2
A
[SOLVED] USB flash drive Write Protected but cant make clean, no bad sectors
Storage
1
P
[SOLVED] SSDs not showing upward in disk management subsequently clean install of win10
Storage
9
[SOLVED] Slow transfer speeds between 2 M.2 NvME Drives on a clean install of windows
Storage
3
P
Question Samsung SSD C Drive Wiped Clean?
Storage
12
A
[SOLVED] Same motherboard, new drive for make clean install of windows.
0 Response to "How To Clean Pins On Hard Drive"
Post a Comment